I’m posting this here before it gets lost in Facebook, Cignal TV did not bother updating their RCU programming instructions on their website. If you were as frustrated as I was trying to figure this one out, well here it is.
First off, definitions..
RCU = Remote Control Unit (see featured image)
STB = Set Top Box
TV = Television (duh)
LED = The red light between the TV and power button
Programming the RCU to your STB
- Press and hold Power and OK.
- Wait for the red LED to blink twice.
- Use keypad, input 982. LED will blink 4 times.
- Press and hold Power and OK. LED will blink twice.
- Key in the STB code, use the codes that refer to your model on this link: http://cignal.tv/Article.aspx?id=15
- Press and hold Power and OK. LED will blink twice.
- Key in 982. LED will blink twice.
- Test if STB control works. (Volume probably won’t, I’ll cover this later)*
Programing the RCU to your TV
- Press and hold TV and OK.
- Wait for LED to blink twice.
- Use keypad, key in 991. LED will blink twice.
- Press minus (-) in CH until your TV turns off.
- Press the TV button, if TV turns back on, press the OK button.
- If TV doesn’t turn on, press the minus (-) button until TV turns back on.
- Press OK to save everything.
*To switch volume control between STB and TV, press and hold OK and VOL+ to use the TV. Wait for the LED to blink twice. Press and hold VOL- to use STB volume controls.
POLDO 